How To: Delete and Reinstall a TireMinder Transmitter

Created by TireMinder Management, Modified on Mon, Jul 6 at 1:13 PM by TireMinder Management

The troubleshooting steps below apply to the following TireMinder models

Remove the transmitter you are replacing from the valve stem.
Remove or replace its battery. Confirm with a voltmeter that the battery's voltage is at or above 3.06 volts.
While in Monitoring Mode on your monitor, press and hold the left and right buttons together to put your monitor into Learn Mode.
In Learn Mode, press and release the right button and navigate around the monitor to the position you wish to replace.
Once on the desired position, press and hold the center button for 2 to 3 seconds. After 2 to 3 seconds, the position will then show "--" on that position.
Attach your new transmitter to the valve stem. Within 5 to 15 seconds, you will see a pressure reading pop up on the display.
Press and hold the left and right buttons for 2 to 3 seconds until to exit Learn Mode and go back to Monitoring Mode.

Remove the transmitter you are replacing from the valve stem.
Remove or replace its battery. Confirm with a voltmeter that the battery's voltage is at or above 3.06 volts.
From the Home screen on your App, tap Learn.
In Learn Mode, tap any available position with a white outline and a plus (+) in the circle.
Tap the desired position and click "Confirm."
Attach your new transmitter to the valve stem. Within 5 to 15 seconds, you will see and hear a confirmation that your transmitter has been learned.
Tap Home to exit Learn Mode and go back to Monitoring Mode.

Remove the transmitter you are replacing from the valve stem.
Remove or replace its battery. Confirm with a voltmeter that the battery's voltage is at or above 3.06 volts.
While in Monitoring Mode on your monitor, press and hold the left and right buttons together to put your monitor into Learn Mode.
In Learn Mode, press and release the right button and navigate around the monitor to the position you wish to replace.
Once on the desired position, press and hold the center button for 2 to 3 seconds. After 2 to 3 seconds, the position will then show "--" on that position.
Attach your new transmitter to the valve stem. Within 5 to 15 seconds, you will see a pressure reading pop up on the display.
Press and hold the left and right buttons for 2 to 3 seconds until to exit Learn Mode and go back to Monitoring Mode.