Support

Articles in this section

How Do I Reset All Tires On My TireMinder

How to Reset All Tires on a TireMinder TM-77, A1A or TM66 TPMS

Want to start over? Follow these directions for the TireMinder A1A and TireMinder TM66 Tire Pressure Monitoring Systems

  1. Make sure you are in Monitoring Mode. Monitoring Mode is the mode where you can switch between temperature and pressure using the right and left button.
  2. Press and hold the left and right buttons for 5 seconds until you hear a beep and see all 22 tire positions on the monitor.
  3. Once you see all 22 tire positions, you can confirm you are in Learning Mode. This mode is where you can add or remove a tire position.
  4. Press and hold the center and right buttons for 5 seconds until you hear a double beep.
  5. Once you hear the double beep, any transmitter that has been previously added to the system will be removed.
  6. To exit Learning Mode, press and hold the left and right buttons for 5 seconds until you hear a beep.
  7. You will now be back in Monitoring Mode.

How to Reset All Tires on the TireMinder Smart TPMS

  1. Touch the ellipse ( ⋮ ) on the top right of the screen. This will pull up the main menu.
  2. Touch on the button labeled “Settings”.
  3. When in Settings, touch the button labeled “Restore to Factory Defaults”.
  4. A menu will pop up, allowing you to confirm or cancel the restoration process.
  5. Click “Yes” to confirm and your TireMinder® TPMS App and Bluetooth Adapter will be restored to factory defaults.

How To Completely Reset a TireMinder TMG400C TPMS

  1. Make sure you are in Monitoring Mode. Monitoring Mode is the mode where you can switch between temperature and pressure using the right and left button.
  2. Press and hold the left and right buttons for 5 seconds until you hear a beep and see all 22 tire positions on the monitor.
  3. Once you see all 22 tire positions, you can confirm you are in Learning Mode. This mode is where you can add or remove a tire position.
  4. Using the right or left buttons, move to the position you wish to remove/unlearn from the monitor. Once you are on the position, press and hold the center button for 5 seconds until you hear a beep.
  5. Once you hear the beep, the monitor will show 3 dashes and the light on the top would have gone from green to red, confirming the removal of the transmitter.
  6. Once all desired transmitters have been removed, you can exit Learning Mode by pressing and holding the left and right buttons for 5 seconds until you hear a beep.
  7. You will now be back in Monitoring Mode. Make sure the amount of tires you have removed are the same amount being displayed in Monitoring Mode. (Example: If you removed 10 transmitters from a total of 12 Transmitter, make sure Monitoring Mode displays only 2 tire positions.)

Note: If you are doing a complete uninstall or a "start over”, slowly go through each position in Learning Mode, starting with the first position and make sure each position displays three dashes and a red light on the top of the monitor. If the position shows a green light, remove the position using the previous instructions.