We’re now ready to program, or what we like to call learn, each transmitter to a tire position. Please see the steps below to learn each transmitter:
Step 1: From Monitoring Mode, press and hold the left and right buttons for 5 seconds until you see an L in the center of the display. See the image to the right? That’s how your display should look right now.
Step 2: On the top left, you should see “- -“ flashing. This is the current tire position. The top left tire position can be used as the driver’s front tire of your vehicle. Alternatively, you can use the left or right buttons to move the current tire position to anyone of the 20 available positions. Once you have chosen the first tire position you would like to learn, proceed to Step 3. Note, to go to the rear section, press and release the right button until you see REAR near the center of the monitor. This notates the REAR
Step 3: With the desired tire position flashing, screw a transmitter onto your vehicles’ corresponding tire position. Within 15 seconds, you should hear a beep and see the current PSI.
Step 4: Continue to use the left or right buttons to select the next tire position you wish to learn. Once at the next desired tire position, screw a transmitter onto that corresponding tire position. Again, within 15 seconds you will hear a beep and see the tire’s current PSI.
Step 5: Repeat Step 4 until all tire transmitters have been learned to the monitoring. Once complete, press and hold the left and right buttons for 5 seconds until you see MONITORING on the display.