The TireMinder i10 is setup to default to PSI and °F (Fahrenheit). If you would like to change this to Bar (barometric pressure) or °C (Celsius), please use the instructions below.
- From MONITORING mode, press and hold the center button for 5 seconds until you hear a beep and see BASELINE in the top center of the display.
- Once in BASELINE mode, you will see PSI flashing. You may use the left or right buttons to toggle from PSI or Bar. With your desired pressure unit selected, press and release the center button.
- °F will now be blinking. Using the left or right buttons, you will be able to toggle between °F (Fahrenheit) or °F (Celsius). With the correct temperature unit selected, you may now exit BASELINE mode by pressing and holding the center button for 5 seconds until you hear a beep and see MONITORING in the top center of the display.
Low Battery Indicator
The i10 monitor has a built-in Lithium-Ion rechargeable battery which under normal use will function for 12 hours before requiring a re-charge. Please note, you can extend the battery life by turning the monitor off when not in use. To do so, press and hold the TOP button for a full 10 seconds until the screen goes blank.
The level of charge is displayed in the top left portion of the screen. You may recharge the unit at any time if you feel it may be necessary. If the last bar disappears, the unit will beep several times and the battery icon will flash. If you don’t plug it in soon, the monitor will shut down completely. To re-charge, simply use the supplied USB charger.
A full charge takes approximately 6 hours. When charging, you will see a lightning bolt to the left of the battery, along with a charging animation inside the battery. Once fully charged, the lightning bolt will disappear, and the animation will stop.