To reset your TireMinder Solar Powered Trailer TPMS, please use the following instructions:
- Remove all transmitters from your valve stems.
- Make sure you are in Monitoring Mode. Monitoring Mode is the mode where you can switch between °F and °C by pressing and releasing the left button.
- Press and hold the left and right buttons on the top of the 5 seconds, release once you hear a beep.
- After the beep you will be in Learn Mode and see the top left tire blinking.
- Select the tire position you would like to reset by pressing and releasing the left or right button.
- Once at the desired tire position, press and hold the center button until you hear a beep and see “---“.
- Repeat Steps 5 and 6 until on tire positions that you would like to reset read “---“.
- Use the right or left button to select the tire position you would like to add back to the monitor. Note, if your system came with 4 tires, please use the transmitter marked 1 on the driver’s front position, 2 on the passenger front position, 3 on the passenger rear position, and 4 on the driver rear. If your system came with 2 transmitters, please use the transmitter marked 1 on the driver side, and the transmitter marked 2 on the passenger side.
- Once at the desired position, screw the transmitter onto the corresponding tire position. Within 12 seconds, you should hear a beep and see the new tire pressure.
- Continue adding the remaining tire positions until all transmitters are back on the valve stems and displaying pressure.
- Once complete, you will need to return to the Monitoring Mode. Press and hold the left and right buttons for 5 seconds, release once you hear a beep.
- You should now be back in Monitoring Mode. Confirm this by toggling the temperature using the left button.